![]() Safari and Mail loaded up a minute or two later. My Airport network came up quickly in the taskbar, with the full four bars lighting up soon after waking/restarting. ![]() I'm on OS 10.6.4 and praying there's going to be a software update fix.Īfter installing 10.6.5, the problems temporarily subsided. Another Mac in the same room, my daughter's MacBook, connects fine - but it's not on Snow Leopard. There's no problem connecting to other wireless networks, eg. I've tried the following: resetting PRAM (holding down Command, Option, P & R during startup), repairing permissions, resetting Airport and ADSL Modem, installing newer Airport firmware, physically siting my computer next to the Airport. Successful connection via ethernet just 'happens', after this wait.Ĭonnection drops out after the computer has been inactive for a while. ![]() Once established, I can then continue the connection wirelessly.Īt all times, trying to connect via password fails due to timing out. Then it takes a couple more minutes for Safari and Mail to load. ![]() Eventually the four bars in the Airport icon to go from greyed out to full. Connection can only be achieved via ethernet cable to the ADSL modem, but doing so requires waiting for 5-10 minutes (occasionally up to an hour) and toggling between Airport On and Off in the taskbar. I'm having real problems connecting my MacBook Pro to my Airport network. If you can, you need to move up to an "n" AirPort Express to allow your network to function at maximum performance. If your devices are not configured as a WDS setup now, then your network is not extending and it's also likely that the incorrect settings are affecting your connection speed. In addition, the bandwidth on the network will be cut by 50%, as you note.īoth of your devices are newer "n" routers. Unfortunately, WDS is a "g" technology, so if you choose to go with this setup, your AirPort Extreme "n" will become a "g" router. If you have an older "b/g" Express, you'll need to configureīoth the AirPort Extreme and the Express to participate in a WDS setup. Sorry, but this information is not correct. I also read somewhere that if both the N-version of the Airport Extreme and Express are used together, one as a base and the other to extend, that the wireless connection can be extended without using WDS, and the connection won't be "cut in half." Is this possible? I am thinking about exchanging my Extreme for a new one. Is it not compatible with the new Airport Extreme to extend the network? I also read somewhere that if both the N-version of the Airport Extreme and Express are used together, one as a base and the other to extend, that the wireless connection can be extended without using WDS, and the connection won't be "cut in half." Is this possible? Can it be that because I am using the old Express that I am having issues. I have done all of these things and have basically no interference.įYI: I am using an Airport Extreme N-Router as my base station, and an Airport Express b/g to extend it. I have read all over these forums, and what I have read over and over again is an Apple representative stating to apply the appropriate settings and/or switch the channel/check for interference. I have full signal strength in the Airport icon at the top right corner of my screen, but a terribly slow connection (.5 mbps download speed). I am trying to extend the range of my Airport Extreme network using an Airport Express.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |